Talk:X86 Assembly/Shift and Rotate

High!

I've included a &lt;ref&gt;&lt;/ref&gt; tag in the new section "Extended Shift Instruction", which didn't show up after saving the page. I was able to resolve it myself, but then...

Rather, but _now_ I realized that the instructions don't show up as wanted, using Template:X86-inst-3, which I defined for exactly this purpose... I don't seem to be able to resolve this issue on my own...

May it have to do with the to-be-reviewed status of the template? But then, it is read in by the page, it just doesn't replace the "Instr" part with "shld" or "shrd", respectively. What could this be about?

Thanks in advance,

Jagged

PS: I don't understand what I did, but I did it... thanks anyway...--Eatingrapunzel (discuss • contribs) 23:24, 3 December 2011 (UTC)

Welcome to the x86 Assembly Wikibook! Thank you very much for your contributions. It's good to see someone else working on this book. By the way, it's not usually necessary to add external links to references, especially since the document you cited is included in the resources section. Jfmantis (discuss • contribs) 04:31, 5 December 2011 (UTC)

Separate shift and rotate
I don't actually get why these instructions are together, when they have only little in common and are used to completely different things. I think they should have separate pages as they are separate and different.

Oset

2A00:F41:2894:B8EB:21F:3CFF:FE31:F779 (discuss) 19:35, 10 February 2024 (UTC)