Reconstruction/Reconstruction/Insulation

The process by which Thermal Insulation is installed.

Materials

 * Fiberglass Insulation
 * Vapor Barrier
 * Staples

Note: R-13 recommended for exterior walls. R-19 recommended for ceilings.

Suggested Tools

 * Tape Measure
 * Utility Knife
 * Dust Mask
 * Staple Gun
 * Ladder

Note: Only install insulation on exterior walls. Paper side facing the interior of the house.

Installation

 * 1) Measure height of wall or length of ceiling
 * 2) Measure and cut length of insulation equal measurement from step 1
 * 3) Place cut piece between studs
 * 4) Cut around outlets, light-switches, and other fixtures
 * 5) Repeat steps 2-4 for each gap between studs throughout house
 * 6) Staple all flaps to face of studs
 * 7) Staple vapor barrier to face of studs

Note: R-13 Wall insulation is typically produced as a continuous roll. R-19 ceiling insulation is typically produced in 7 ft sections. Multiple pieces may be used to fill a gap. Gaps are typically 15 inches wide.