Reconstruction/Mold Treatment/Mold Treatment/Scrub and Spray

The two part process by which wood is treated in order to kill mold and treat wood against future mold growth.

Scrubbing
Materials:
 * Five Gallon Bucket
 * Water
 * Bleach
 * Original Pine-Sol
 * Large, Heavy-Duty Sponge (one per person)

Suggested PPE:
 * 3M Half-face respirator with p100 filters
 * Rubber or Latex Gloves

Procedure:
 * 1) Fill the 5 gallon bucket with approximately 4.5 gallons of water.
 * 2) Pour 3 ounces of Pine-Sol and 9 ounces of Bleach into the water. Stir well.
 * 3) Soak a sponge in the solution.
 * 4) Scrub sponge against wood areas, including walls, beams, and staircases. Apply generously so that solution has visibly soaked into the wood.
 * 5) Re-wet sponge as necessary to ensure that there is enough solution being applied.
 * 6) Repeat steps 4 and 5 until all areas are covered. If solution runs out, repeat steps 1 and 2 to create more.
 * 7) Let wood dry before beginning the following spray process.

Spraying
Materials:
 * Five Gallon Bucket
 * Water
 * Timbor Solution
 * 16oz. Scoop
 * Stirring Rod
 * Sprayers

Suggested PPE:
 * 3M Half-face respirator with p100 filters
 * Rubber or Latex Gloves

Procedure:
 * 1) Fill the 5 gallon bucket with approximately 4.5 gallons of water
 * 2) Slowly pour in a 16oz. scoop of Timbor, while continually mixing, assuring that all particles are dissolved
 * 3) Repeat for a total of ten scoops.
 * 4) Fill mixture into sprayers.
 * 5) Spray all wood areas so that they are coated in the Timbor solution.
 * 6) Refill sprayers and remix Timbor solution as necessary.
 * 7) Continue process until all wood areas are covered.