Flute/Tonguing

Basic tonguing
Unless specified in music, notes should always be tongued. At this point you should know how to produce sound. If you do not, read the previous lesson. If you do, begin by producing sound a few times. As you begin to blow each note, move your tongue as if you were saying "tu" (pronounced "too") or "du" (pronounced "do"). Practice this until you have a smooth sound. After this, play several notes. This is done by blowing a single stream of air separated by the sylables of "tu". As you practice this remember a few things: When tonguing, use the tip of your tongue to produce a clearer sound, this also prevents the sound from sounding like "lu". Also listen to the sound, if the sound stops completely, you tonguing is too heavy. If this happens, just don't say the syllables as heavily.

The objective of basic tonguing is to produce notes with a clearer-sounding attack. The tongue should act like a pressure release valve, attacking each note with a strong stream of air.

Staccato (short) tonguing
From the basic tonguing, change the syllable to "ta" or "da", and cut the air stream off after half of the notes value. Do not, just lower the amount of air you use, or you will produce a marcato effect. Also, do not use too much air, or you will get a rinforzando or accented note.

Tonguings to avoid
Do not use "ba", "ma" or "pa". These start with the lips closed, and cause the sound to be ambiguous at the beginning of a note, which is for the most part a bad sound.

For now, do not use "ku" or "qu" (pronounced "Coo") or "Gu" (pronounced "Goo"). These tonguings will be used later with double tonguing, but get used to basic tonguing first.

Don't use "la", "ya", "sa" or "za". These produce a vibrato like sound. "Ha" is used to produce a vibrato, but don't worry about that now.