Automobile Repair/Radiator flush and fill

IMPORTANT MAKE SURE ENGINE IS COOL * HIGH PRESSURE AND HOT COOLANT CAN CAUSE BURNS* There are several reasons for flushing your radiator but here are basics steps to complete this task. Gather these items prior to starting a flush.


 * 1) antifreeze coolant
 * 2) drain pan/bucket
 * 3) drain hose ( if needed )
 * 4) any other replacement parts i.e. rad cap, thermostat, hoses, radiator, etc.

Once you have your supplies start by ensure engine is cool. DANGER DO NOT OPEN HOT UNDER PRESSURE
 * 1) open rad cap slowly to relieve any pressure.
 * 2) open drain on bottom of radiator.
 * 3) cycle run water through system until clean (this can take awhile depending on engine condition.
 * 4) close drain. fill rad with coolant to specified level usually with engine running and rad cap off.
 * 5) fill over flow if required
 * 6) check for leaks.